6 RADIUS Home
2. Installation
2.1 Installationmanual
A) Do not remove the casing. Inverter contains no user serviceable parts. Refer servicing to qualied serv-
ice personnel.
B) Both AC and DC voltage sources are terminated inside the PV Inverter. Please disconnect these circuits
before servicing.
C) When a photovoltaic panel is exposed to light, it generates a DC voltage. When connected to this equip-
ment, a photovoltaic panel will charge the DC link capacitors.
D) Energy stored in this equipment’s DC link capacitors presents a risk of electric shock. Even after the unit
is disconnected from the grid and photovoltaic panels, high voltages may stili exist inside the PV-Invert-
er. Do not remove the casing until at least 10 minutes after disconnecting all power sources.
E) This unit is designed to feed power to the public power grid (utility) only. Do not connect this unit to an
AC source or generator. Connecting the inverter to external devices could result in serious damage to
your equipment.
F) Carefully remove the unit from its packaging and inspect for external damage. If you nd any imperfec-
tions, please contact your local dealer.
G) Although designed to meet all safety requirements, some parts and surfaces of inverter become hot
during operation. To reduce the risk of injury, do not touch the heat sink at the back of the PV-Inverter or
nearby surfaces while Inverter is operating.
Warning!
To Next Page
Loading...
Need help?
General