Gehl CTL60 - Seat and Seat Belt

40
CONTROLS
Doors and Covers
Lift Arm Stop
WARNING
¡¡
¡¡
¡If you must work beneath the raised lift
arms, securely engage the lift arm stop.
Never get under the lift arms and
bucket if they are not sufficiently
supported.
¡¡
¡¡
¡Service the lift arm stop if damaged or
if parts are missing. Using a damaged
lift arm stop or with missing parts can
cause the lift arms to drop causing
injury or death.
Maintenance and service work can be done
with the lift arms lowered. If the lift arms are
raised, use the following procedures to
engage and disengage an approved lift arm
stop.
Engagement
1. Park the machine on level ground and
remove the bucket.
2. Lower the lift arms to the ground and stop
the engine.
3. Remove the rear R-pin (4) from the locking
pin (1).
4. Support the lift arm stop (2) by hand and
pull out the locking pin (1).
5. Check that the spring (3) moves freely (i.e.,
is disengaged from the hook (5)) and place
the lift arm stop (2) on the cylinder.
6. Sit in the seat, fasten the seat belt, start
the engine and lower the safety bar.
7. Raise the lift arms slowly until the lift arm
stop (2) drops onto the cylinder rod.
8. Lower the lift arms slowly until the lift arm
stop is held between the lift arm and the
end of the cylinder tube.
9. Stop the engine.
10. Install the locking pin (1) into the rear of
the lift arm stop (2) below the cylinder
rod.
11. Install the R-pin (4) to the locking pin (1).
T9B001
T9B002
T9B003