Gehl RS6-34 - Page 130

RS5-34 Telescopic Handler FRONT AXLE
PRINTED IN U.S.A. 503-2 913241
Alt
=
to
hide
template
information
Alt+ to display template information
Template
Name:
OML
_
2
_
col
907871E
Template Date: 1997_02_12
STEP 2
G0805206
Place wood blocks between the rear axle and the
frame (both sides) to prevent the frame from rotating
when the frame leveling cylinder is disconnected.
STEP 3
G0805207
Remove the retainer bolt (1) and pin (2) from the
lower pivot pin on the frame leveling cylinder.
STEP 4
G0805208
Remove the lower pivot pin from the frame leveling
cylinder.
STEP 5
G0805044
Disconnect the driveshaft from the front axle by
removing the four bolts and lock washers.
STEP 6
G0905067
Disconnect the driveshaft from the transmission by
removing the four bolts and lock washers. Remove
the driveshaft from the machine.
STEP 7
G0905068
Mark the two hydraulic hoses for correct assembly.
Loosen and remove the two hydraulic hoses from the
steering cylinder.
2
1
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com