NEW OPERATOR DRIVING PROCEDURE
1. Disconnect the charging cable (if connected).
2. All riders should wear substantial footwear, long pants and a close-fitting
shirt. A hard hat or helmet and approved eye protection are recommended
when appropriate for working or riding conditions.
3. Sit in the driver's seat and fasten the seat belt. Make sure passenger is
seated with seat belt secured.
4. Adjust mirrors as needed.
5. Apply the brakes. Place the direction selector in neutral (N).
6. Apply the brakes. Turn the key to the ON position. Wait about a second for
the contactor to close before continuing.
7. Move the direction selector to forward or reverse.
8. Release the park brake.
9. Check your surroundings and determine your path of travel.
10.Keeping both hands on the steering wheel, release the brake pedal and
gradually push the accelerator toward the floor to begin driving.
11. Drive slowly. Practice maneuvering and using the accelerator and brakes on
level surfaces.
12.Before turning, activate a turn signal to alert others of your intentions. See
page 22.
46
OPERATION
To Next Page
Loading...