HEADLIGHT BEAM ADJUSTMENT
1. Place the vehicle on a level surface with the headlight approximately 25 ft.
(7.6 m) from a wall
q
.
2. Measure the distance from the floor to the center of the headlight and make a
mark on the wall at the same height.
3. Apply the brakes. Turn the key on. Turn the headlights on.
4. Observe the headlight aim. The most intense part of the headlight beam
should be aimed 8" (20 cm) below the mark placed on the wall
w
. Include
the weight of a rider on the seat while performing this step.
5. If a headlight needs adjustment, access the adjustment screw under the
hood or through the wheel well.
6. Loosen the headlight adjustment screw, adjust the headlight, and tighten the
screw.
7. Repeat steps 4-6 until the lamp is properly adjusted.
BRAKE LIGHTS
When the brake pedal is depressed, the brake light comes on. Check the brake
light before each ride.
1. Turn the key to the ON position.
2. Apply the brakes. If the light doesn't come on, check the wiring, the brake
switch or the tail light assembly.
79
MAINTENANCE
To Next Page
Loading...