8. Make sure the charger uses a dedicated circuit to prevent overloading. If
charging multiple vehicles, each vehicle should use a dedicated circuit.
9. When disconnecting the charger, always disconnect the extension cord from
the wall receptacle first, then disconnect the cord from the vehicle’s charge
receptacle.
TIP
If the charger turns off due to an overheated condition (thermal cutback),
remove the seat to improve air flow. Reset the charger (interrupt AC power for
15 seconds).
TIP
After the batteries have fully recharged, the battery charger will automatically
cycle in and out of the trickle charge mode to maintain the charge.
BATTERY INSPECTIONS/MAINTENANCE
WARNING
Do not work in or near the battery compartment or on any other electrical
component of the vehicle while charging the batteries. Before servicing the
vehicle’s electrical system, always disconnect the main power connector first,
then disconnect any electrical accessory connections, then disconnect the
negative cable from the 12-volt battery (if equipped), then disconnect the
negative terminal from the main battery pack. This will disable the vehicle by
disconnecting the battery pack from the motor. It does not disable the battery
pack. HIGH VOLTAGE will be present at the battery terminals. HIGH
BATTERY VOLTAGE IS ALWAYS PRESENT. DO NOT TOUCH THE
BATTERY TERMINALS.
BATTERY ACCESS
To access the batteries, remove the seat. See page 39. Remove the storage tray
(if equipped).
NOTICE
Before removing the seat to access the batteries, make sure any wire or metal
items (including seat belt latches, if equipped) remain clear of the battery
compartment to avoid causing a short circuit to the electrical system.
83
MAINTENANCE
To Next Page
Loading...