BATTERY REPLACEMENT
WARNING
Handling batteries and electrical components improperly can result in serious
injury or death. Do not attempt to remove batteries or battery cables. Battery
posts are identified on the battery case as positive (+) and negative (-). Your
authorized GEM dealer can provide battery-related service
With proper care and maintenance, as outlined in this owner’s manual, battery
life can be maximized, but the battery will eventually reach the end of its useful
life. When battery replacement is necessary, your authorized GEM dealer can
provide this service.
NOTICE
Always install batteries of the exact type and make originally supplied with the
vehicle to prevent damage to the vehicle’s electrical system.
BATTERY CLEANING
1. Remove corrosion with a stiff wire brush.
2. Wash the terminals and tops of the batteries with a solution of one
tablespoon baking soda and one cup water. Rinse well with tap water and dry
off with clean shop towels.
3. Make sure battery terminals are tight. Use an insulated wrench to tighten as
needed.
4. Allow battery terminals to dry, then coat the terminals with dielectric grease
or petroleum jelly, or spray them with battery anti-corrosion spray.
NOTICE
Do not allow cleaning solution or tap water to enter the batteries. Before
cleaning, make sure all battery fill well caps are installed securely.
BATTERY DISPOSAL
Return to an appropriate battery recycling facility. For neutralized spills, place
residue in acid- resistant containers with absorbent material, sand or earth and
dispose of in accordance with local, state and federal regulations for acid and
lead compounds. Contact local and/or state environmental officials regarding
disposal information. You can also contact GEM Customer Service for
information.
84
MAINTENANCE
To Next Page
Loading...