EasyManuals Logo

Gemalto SafeNet Luna Network HSM 7.0 User Manual

Gemalto SafeNet Luna Network HSM 7.0
52 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
3 SafeNet Luna HSM Client Software Installation
Product or
component
Description
RB_SNMP SNMP subagent component forthe SafeNet Luna Backup HSM
For example, the following command installs the base software and the optional component:
LunaHSMClient.exe /install /l install.log /quiet /norestart ADDLOCAL="RB,RB_SNMP"
Installing the Luna HSM Client for Remote PED
Use the ADDLOCAL=RP flag to install the client software for the SafeNet Luna Backup HSM.
Note: The setting /l install.log is optional and will save the installation logs to the file
install.log. The install.log file is required only if troubleshooting an issue with Technical
Support.
To install the Luna HSM Client for the SafeNet Luna Backup HSM
From the location of LunaHSMClient.exe run the following command:
LunaHSMClient.exe /install /l install.log /quiet /norestart ADDLOCAL="RP"
Uninstalling the Luna HSM Client
You can also perform scripted/unattended uninstallation.
Note: The setting /l uninstall.log is optional and will save the installation logs to the file
uninstall.log. The uninstall.log file is required only if troubleshooting an issue with Technical
Support.
To uninstall the Luna HSM Client
From the location of LunaHSMClient.exe run the following command:
LunaHSMClient.exe /uninstall /quiet /l uninstall.log
SafeNet Luna Network HSM Installation Guide
Release 7.0 007-013576-002 Rev. A June 2017 Copyright 2001-2017 GemaltoAll rights reserved.
52

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Gemalto SafeNet Luna Network HSM 7.0 and is the answer not in the manual?

Gemalto SafeNet Luna Network HSM 7.0 Specifications

General IconGeneral
BrandGemalto
ModelSafeNet Luna Network HSM 7.0
CategoryNetwork Hardware
LanguageEnglish