2
SafeNet Luna Remote PED Installation and
Configuration
This chapter describes how to install, connect, and configure a SafeNet Luna Remote PED.
The standard PED is intended to connect directly to the HSM, and receives its power, as well as instructions and data
via that connection. The Remote PED can act as a local PED, when needed, and connects as described above. When
used in Remote PED mode, the PED connects to a computer via USB, and therefore requires some additional
hardware.
Remote PED can be distinguished from local PED by:
• An orange label PED Remoteto the right of the SafeNet logo
• Availability of menu item 7 Remote PED from the PED's main menu
Required Items
The following items are included with your Remote PED. All are required for a successful installation.
Quantity Item
1 PED (Remote PED Capable and with firmware 2.7.1 or newer)
1 PED Power Supply kit with replaceable mains plug modules for international use (required when the
PED is operated in Remote PED mode)
SafeNet Luna Network HSM Installation Guide
Release 7.0 007-013576-002Rev. A June 2017 Copyright 2001-2017 GemaltoAll rights reserved.
26
To Next Page
Loading...
Need help?
General