Installation Procedure
1. Unpack the Internet Camera package and verify that all the items
listed in the Chapter 2 are provided.
2. Connect the Internet Camera to your network by attached the
network cable from the switch/router to the UTP port of the Internet
Camera.
3. Connect the power adapter to the Internet Camera and plug the
power adapter to power outlet. The Internet Camera will be
powered on. When the Internet Camera is ready, the Ready LED will
light.
4. Make sure that you have installed correct VGA driver and DirectX 9.0
or above.
Note: It is highly recommended to use the power adapter shipped with
the Internet Camera, do NOT use any other power adapter from any
sources.
To Next Page