Using the Administrator Utility
The Administrator Utility allows users to search and setup the cameras
located within the Intranet or on the Internet. From the utility, users can
view all the information of the selected camera; furthermore, it provides a
setting wizard, which can guide users to add the camera to the network
easily and promptly.
There are two ways to run the Administrator Utility as follows.
1. Click “Start”, select “Programs\IP Camera\Admin Utility” to run the
utility.
2. Double click the “IP Camera Admin” icon to run the utility.
Once the utility is started, it will search all the cameras within the network.
To do more settings, please refer to the description in the following
sections.
To Next Page
Loading...