032-0207-EN Rev 0
Articulated Arm - Vertical Drifting
3-7
Articulated Arm - Vertical Drifting
Outer Section
Figure 3-6 shows the location referred to as the outer section of the
Articulated Arm (the section nearest the Tubehead).
Figure 3-6 Locating the Outer Section of the Articulated
Arm
Ensure that you follow the procedure referenced in the following step.
This equipment must always be electrically disconnected from the
mains electrical supply (external power source) before beginning any
procedure.
(Continued)
Tools Required: 7 ½" (190 mm) long 5/16" (8 mm) Allen Wrench
- or -
8” (203 mm) long 8 mm T-handle Allen Wrench
Small Flat Head Screwdriver
Printed on: 20 Apr 2012, 11:34:10 am; Printed by: UWE.ZELLER
To Next Page
Loading...
