35
15. Shut OFF utility power again to automatically start the
generator. When power on the lower half of the load center
has transferred to the generator, turn ON each of the branch
circuit breakers in the lower half of the load center, one at a
time, until the generator has accepted the entire priority load.
16. With the generator carrying the entire priority load, re-check
gas pressure to verify that it’s at the same level it was before
the generator was started.
NOTE: Even if the generator is running smoothly at this point, a
drop in gas pressure indicates that the supply is barely adequate
to supply the generator’s needs. Changes in the generator load,
or additional gas demand by other appliances may affect the
generator’s performance. Verify gas pressure and pipe sizing.
Unhook the manometer and reinstall the port plug.
APPENDIX F - SETTING THE AUTOMATIC
EXERCISE FUNCTION
1. To set the exercise on 8 kW models, make sure with the
mode
switch is in AUTO. Press and hold down the EXERCISER
switch
for at least 10 seconds and release. The generator should
start within a few seconds. The unit will run for about 12
minutes before shutting itself down automatically.
If the battery is ever disconnected or the fused is removed for
any reason, the exercise function will have to be reset.
2. On all other models, the display will enter an Installation Assistant
mode when battery power is first connected. The assistant will
prompt to first enter the current date and time, followed by the
exercise day and time.
If the battery is ever disconnected and reconnected, or fuse
removed and replaced, the Installation Assistant will be displayed
again, but only the current date and time will need to be entered.
3. If the exercise time or day ever needs to be changed, press
the escape key to access the main menu.
4. Press the left or right arrow key until ‘Edit’ is flashing and press
enter.
5. Press the right or left arrow key until the exercise time is
displayed and press enter.
6. Using the arrow and enter keys first set the exercise hour in
24 hour format, followed by the minute, and finally the day.
To Next Page
Loading...
Need help?
General
