Need help?Do you have a question about the Generac Power Systems R-200 and is the answer not in the manual?
General| Brand | Generac Power Systems |
|---|---|
| Model | R-200 |
| Category | Controller |
| Language | English |
Manufacturer's recommendation to copy and post safety rules in hazard areas.
General safety precautions and recommendations for installation and servicing.
Warnings regarding dangerous electrical voltages and shock prevention.
Safety requirements for generator installation, maintenance, and compliance with codes.
Explanation of DIP switch functions for configuring generator operation modes.
Description of front panel LED indicators and their meanings.
Specifies engine timing for NG/LP fuels and details initial cranking process.
Explains Manual, Auto, Utility Failure, and Utility Restored modes.
Details normal (3600rpm) and low-speed (1800rpm) exercise modes.
Covers active alarms, re-crank procedures, and fault conditions like overspeed.
How to manually start the generator and conditions for the System Ready LED.
Details on Low Fuel, Low Battery, Low Oil, High Temp, and Overspeed LED indicators.
Explains RPM signal failure during crank/run and the overcrank fault.
Covers impact of incorrect DIP settings and how to cancel alarms.
Details how the generator operates with an ATS for utility transfer.
Illustrates the wiring diagram for the generator in ATS mode.
Describes setup and operation with a W-type transfer switch for GTS mode.
Shows wiring for the generator in GTS mode with a W-type transfer switch.
Information on potentiometers for voltage regulator settings.
Details pin assignments for J1 (23-pin) and J2 (14-pin) connectors.
Describes the 2 Amp float and 10 Amp equalize battery chargers.
Specifications for the 2A charger, including fuses and indicators.
Warnings regarding battery hazards (gas, acid) and booster battery use.
Details for the 10A charger, including charge rates, voltages, and indicators.
To Next Page
