General Measure M02 - 7 Password Input and Setting, Reset; 7.1 Password Input

To Next Page

To Previous Page

M02 Digital Indicator

7 Password Input and Setting, Reset

7.1 Password Input

（1）Indicator calibration and working paraters setting default password: 000000.

（2）User can set password in parameters when F4.1 is“ON”.

（3）When display is “PASS”, need to input correct password to enter parameters.

Note:

（1）When input password, if first time wrong, it will go to the second chance for

password input(display from turn to ).

（2）If second input wrong, it will enter into interface for inputting password the third

time

(Display change from to ).

（3）If Input wrong for three times, main display show “Error4” and self-lock, but user

can operate when power on again.

7.2 Password Setting

（1）User can set password in parameters when F4.1 is“ON”.