ELECTRICAL REQUIREMENTS
Connect the motor plugs and then plug the bandsaw into a proper
receptacle. Your power tools should be connected to a dedicated
electrical circuit of not less than #12 wire and should be protected with
a 15 amp time lag fuse.
GROUNDING:
In the event of an electrical malfunction or short circuit,
grounding reduces the risk of electric shock to. The motor of this
machine is wired for 110V single phase operation and is equipped
with a 3-conductor cord and a 3-prong grounded plug to fit a ground-
ed type receptacle, . Do not remove the 3rd prong (grounding pin)
to make it fit into an old 2-hole wall socket. If an adaptor plug is used,
, it must be attached to the metal screw of the receptacle.
Note: The use of an adaptor plug is illegal in some areas. Check
your local codes.
Before connecting the machine to the power source, verify that the voltage of your power supply corresponds
with the voltage specified on the motor I.D. nameplate. A power source with greater voltage than needed can
result in serious injury to the user as well as damage to the machine. If in doubt, contact a qualified electrician
before connecting to the power source.
This tool is for indoor use only. Do not expose to rain or use in wet or damp locations.
DO NOT MODIFY THE PLUG PROVIDED.
If it will not fit your receptacle, have the proper receptacle installed by a qualified electrician.
CHECK with a qualified electrician or service person if you do not completely understand these grounding instruc-
tions, or if you are not sure the tool is properly grounded.
EXTENSION CORDS:
USE ONLY 3-WIRE EXTENSION CORDS THAT HAVE 3-PRONG GROUNDING PLUGS AND 3-POLE RECEPTACLES THAT ACCEPT
THE TOOLS’ PLUG. REPAIR OR REPLACE A DAMAGED OR WORN POWER CORD OR PLUG IMMEDIATELY.
If you find it necessary to use an extension cord with your machine make sure the cord rating is suitable for the
amperage listed on the motor I.D. plate. An undersized cord will cause a drop in line voltage resulting in loss of
power and overheating.The accompanying chart shows the correct size extension cord to be used based on cord
length and motor I.D. plate amp rating. If in doubt, use the next heavier gauge.The smaller the gauge number, the
heavier the cord.
AMPERES
(AMPS)
EXTENSION CORD LENGTH
25 FEET 50 FEET 100 FEET 150 FEET
<6 18 16 16 14
6 TO 10 18 16 14 12
10 TO 12 16 16 14 12
12 TO 16 14 12 NA NA
4
NA = Not Available
To Next Page
Loading...
