ASSEMBLY INSTRUCTIONS
ASSEMBLING THE STAND
1.
Lay the top plate upside down on a flat sur-
face.
2. Attach the 4 legs to the outside of top plate
using 4 carriage bolts, washers, and nuts
.
Note: Do not tighten hex nuts until all fasteners
are attached.
3. Attach 2 long brackets and 2 short brackets
to the inside for the legs, using carriage bolts
,washers, and nuts .
4. Place the foot pads on the bottom of each
leg.
5. Place the stand on a flat surface to square it up
and finally tighten all the nuts.
The bandsaw is heavy. The help of an assis-
tant will be needed to lift the bandsaw.
1. Lift the saw body with the help of an assistant
and place it on the stand.
2. Using 4 long hex head bolts , 8 flat washers
, and 4 hex nuts , secure the bandsaw to
the stand and tighten all mounting bolts.
ATTACHING THE BANDSAW TO STAND
ATTACHING DUST PORT
1. Remove the bolts and washers from the dust
port.
2. Open the lower wheel cover door
.
3. Attach the dust port to the edge of the door
using the same hex head bolts and washers .
4. Tighten the bolts and close the door.
7
The dust port has a 2-1/2” opening
to accommodate
connection to a dust collector (not included).
To Next Page
Loading...
