MOUNTING THE TRUNNION SUPPORT BRACKET
1. Remove the 2 hex head bolts and washers
, located on the lower band saw housing.
2. Place the trunnion support bracket on the
saw body, aligning the mounting holes.
3. Place the washers on the hex head bolts, and
insert into the threaded holes, through the
bracket and saw body. Tighten.
5. Place a lock knob on each bolt and adjust
the table, aligning the zero scale mark to the
pointer , then tighten the knobs .
90° CW
INSTALLING 90° TABLE TILT STOP BOLT
1. Remove the table insert from the table.
2. The extension table must be removed before
placing table onto saw. Unscrew the stop-
screw on the rear extension table guide bar
and pull the extension table off of the main
table.
1. Thread the nut onto the table stop bolt and
screw bolt into the rear tab on the trunnion
support bracket. Tighten the nut down onto the
bracket tab.
2. After installing the table, the 90° stop bolt can be
adjusted up or down as needed to “stop” the
table at 90° to the blade.
INSTALLING THE BANDSAW TABLE
3. Guide the table slot over the saw blade and
rotate 90° clockwise so the slot is perpendicular
to the blade.
4. Slip the 2 table tilt trunnion bolts through the
holes in the trunnion brackets (front & rear) as
shown.
8
To Next Page
Loading...
