29
TROUBLESHOOTING
No Power
• Check and make sure whether the fuse is blown,
replace fuse with proper value if necessary.
Some errors occur in the LCD or no function when
pressing the button.
• Turn off the unit and restart the unit again. Use
Factory Default Restart.
Poor radio reception or static.
• Antenna may not be the proper length. Make sure
the antenna is fully extended. Antenna may be
broken. Replace antenna.
• The broadcast signal is too weak.
• The antenna is poorly grounded. Check and make
sure the antenna is properly grounded at it’s
mounting location.
Disc cannot be loaded
• Disc is loaded in the machine. Clear the disc by
pressing eject
No Picture.
• The Video line from the main unit to the TV is not
connected properly. Check connections.
• Improper setting of the TV SYSTEM. Set the TV
SYSTEM to “PAL” or “NTSC”, according to the
connected television.
Disc error appears.
• The disc may be damaged or dirty.
Clean disc and retry.
When there is no color on video.
• Turn off the unit and restart the unit again.
Use Factory Default Restart.
FACTORY DEFAULT RESTART
Press and hold MODE button for 10 seconds - Unit will shut off.
Restart unit by pressing the ON button. Factory defaults will be
reset with this type of restart.
NOTE:
If any of the problems persist after check list has been made,
consult your nearest service dealer.
Never attempt to disassemble your unit by yourself.
To Next Page
Loading...