10
The quick release closes with the
correct holding force when counter-
pressure is visible at the centre of
the lever movement and the force of the ball
of your thumb is required to close the lever
completely.
/
Possible positions for adjusting bolted connections
Possible positions of quick releases / through axles
* see page 34
If your bicycle has one or several full
oating axles, please read the cor-
responding instructions provided by
the component manufacturer on how to oper-
ate and service these parts.
Using quick releases and through axles
Quick releases and through axles are systems
installed on the bicycle in place of bolted con-
nections. They consist of two parts: The clamp-
ing lever, which provides the necessary clamping
force, and the locking nut, which allows you to
regulate the clamping force. You can change the
setup of your quick release when the clamping
lever is open.
For detailed information, please
read the instructions supplied by the
manufacturer. The functionality and
secure t of the suspension parts are vital for
your safety!
Adjusting the bicycle to the rider
The seat post, seat, stem and handlebars can
only be tightened and secured with quick releas-
es or bolted connections.
Tightening adjustment nuts
Loosening adjusting nuts
To Next Page
Loading...
