36
/
Working lights are essential for sur-
vival! Have them checked and re-
paired by a specialist dealer.
Side dynamos are usu-
ally switched on by pres-
sure from the top.
The switches for hub
dynamos are at the
rear of the headlight or
on the handlebars. The
light system will auto-
matically switch on or off
when it is equipped with
a sensor.
Please read the operating instruc-
tions supplied for your light system.
If a light is not working properly, the
bulb is usually broken in conventional lights. If
you feel condent, you can check this yourself
and install a replacement bulb. Suitable bulbs
are available from your specialist retailer. It is
not possible to replace the bulbs in modern
LED lights.
Clean your reectors and lights on
a regular basis. Warm water with
cleaning uid or washing up liquid is
suitable here. It is also important to keep the
contact points in good condition with a suit-
able spray lubricant.
Accessories/ maintenance/ spare parts
Light system
Attached accessories
5m
e.g.. 1m
0.5m
Lighting system
The type of replacement light bulbs depend on
the lighting system installed in your bicycle. The
following list provides a guide for nding the right
bulb.
Dynamo
The dynamo generates the required electrical
energy for the front headlight and the rear lights.
Hub dynamo
If your bicycle uses a hub dynamo, you can
switch this on and off easily on the rear side of
your front headlight with the on/off switch. The
dynamo automatically switches on or off when
the lighting system of your bicycle has a light
sensor.
Lighting
used
Technical information
on the lights
Front light 6 V 2.4 W
Front light
halogen
6 V 0.6 W
Rear light 6 V 0.6 W
Rear light with
standlight
6 V 0.6 W
LED lighting LEDs
cannot be replaced
Dynamo 6 V 3 W
Hub dynamo 6 V 3 W
Cable
Hub dynamo
Connector cover
connect
remove
To Next Page
Loading...
