47
/
Before the rst ride
The following procedures have to be performed
in addition to the tests described in the “Before
the rst ride” Chapter of the technical part of your
operating instructions:
Check the important components of your
Pedelec
• Please check that the battery is secure.
• Check the charging state of your battery to
ensure sufcient charge for the planned ride.
• Check that all plugs and connections of the
electrical system are rmly attached.
• Familiarize yourself with the functions of the
operating panel.
Before getting on the bike, make sure all screws,
quick-release mechanisms, through axels, and all
important components are securely and properly
fastened. A table with the most important screw
connections and the prescribed fastening torques
as well as notes concerning the correct
use of quick releases can be found at
page 10 and 34
Possible positions of quick releases / through axles
Notes on electrical and electronic components
Your pedelec is supplied with the corresponding
operating manual for the integrated motor from
the component manufacturer.
Information concerning operation, mainte-
nance and servicing as well as technical data can
be found in these instructions and on the web-
sites of the respective component manufacturers.
The electrical system of your Pe-
delec is very powerful. Correct and
safe operation requires regular main-
tenance by a specialist dealer. Immediately
remove the battery when you discover dam-
age to the electrical system or, in particular,
when live parts are exposed after a fall or ac-
cident. Always contact your specialist dealer
for repairs and when you have a question
or problems or discover a defect. A lack of
specialist knowledge may lead to severe ac-
cidents and injuries.
Switch off the electrical system and
remove the battery before carrying
out any type of work on the Pedelec.
1
2 3
To Next Page
Loading...
