49
/
Loading the battery
1. Remove the charger, which is delivered with
the product, from its packaging and insert the
mains plug into a socket with a 230 to 240 V
current.
For safety reasons the charger has
to stand and to be used on a dry and
nonammable surface.
2. The charging process starts as soon as the
plug of the charger is connected to the battery.
When the charger has an LED, it will light up.
Progress in charging the battery is indicated
by the number of LEDs on the bat-
tery lit up and the way they light up.
The charging process takes place
in several steps. Usually, the LED
representing the current charging
step ashes. The LED lights up
permanently when this step has
been completed. The battery
charging process is completed
when all LEDs have gone out.
3. After completing the charging process, please
remove the power cord of the charger from the
mains.
A defective battery may not be
charged or used.
The battery may get warm during
charging. Temperatures up to a maximum
of 45°C are within the permitted range. The
charging process stops when the temperature
is higher.
When your charger has an LED and
this LED ashes permanently, it usu-
ally indicates a charging fault. Have
the changer and the battery checked by a
specialist dealer.
Never place or store several accus
on each other. Especialy not while
charging.
Children or Persons that owing to
their physical, sensory or mental limi-
tations or their lack of experience or
knowledge, are not capable of securely operat-
ing the charger, may only use this charger un-
der supervision or after having been instructed
by a responsible person. Otherwise, there is
danger of operating errors and injuries.
The allowed temperature range to
charge a battery is from 0°C to 40°C.
Disconnect the battery pack from the
charger when it is not within the charging-tem-
perature range.
Do not connect the battery pack to the charger
until it has reached the allowed charging tem-
perature.
Charger
• Only use the original charger or one that has
been released by the manufacturer.
• Only use the charger in dry rooms. There is
otherwise a risk of a short circuit or a re.
• Pay attention that the charger is well venti-
lated during the charging procedure and that
the ventilation openings on both sides are not
clogged or contaminated.
• Always pull the mains plug out of the socket
before cleaning the charger.
• The battery should be removed and the charg-
er should be disconnected from the mains once
the charging process has been completed.
Take note of the instructions on the
charger before starting to charge the
battery.
Superwise children. They should not
play with the charger.
Use caution when touching the
charger during the charging proce-
dure. Wear protective gloves. Es-
pecially in high ambient temperatures, the
charger can heat up considerably.
To Next Page
Loading...
