EasyManua.ls Logo

Genex SG7600EX - Preoperation Check

Genex SG7600EX
37 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PRE-OPERATION CHECK
Engine Oil
Engine oil is a major factor affecting engine performance and
service life. Non-detergent and 2-stroke engine oils will damage the engine
and are not recommended.
Check the oil level BEFORE EACH USE
with the generator on a level surface
with the engine stopped.
Use HONDA 4-stroke oil, or an
equivalent high detergent, premium
quality motor oil certified to meet
or exceed U.S. automobile manufacturers
requirements for Service Classification SG, SF/CC, CD.
Motor oils classified SG, SF/CC, CD
will show this designation on the container.
(1) SG SF/CC CD SINGLE VISCOSITY
(2) SGSF/CCCD MULTI VISCOSITY
SAE 10W-30 is recommended for general, all-temperature use. Other viscosities
shown in the chart may be used when the average temperature in your area is
within the indicated range.
1. Remove the oil filler cap and wipe the dipstick clean.
2. Check the oil level by inserting the dipstick into the filler neck without screwing
it in.
3. If the level is low, fill to the top of the oil filler neck with the recommended oil.
16
OIL FILLER HOLE
OIL FILLER CAP