CONTROLS
Engine Switch
To start and stop the engine
Switch position
OFF: To stop the engine. Key can be removed / inserted.
ON: To run the engine after starting
START: To start the engine by turning the starter motor.
Return the key to the ON position once the engine has started. Do not use the
starter for more than 5 seconds at a time. If the engine fails to start, release the
switch and wait 10 seconds before operating the starter again.
Recoil Starter
To start the engine, pull the starter grip lightly until resistance is felt, then pull
briskly
Do not allow the starter to snap back against the engine. Return it
gently to prevent damage to the starter.
7
To Next Page
Loading...