The first time you press EXIT, or select Watch TV or Browse Guide after adding your WGM(s), a
software download will occur to deliver the latest features from DIRECTV. This may take a
few minutes.
To move your activated WGM to another room in your home, disconnect the HDMI & power cables,
and reconnect at your desired location. Verify a sufficient wireless signal by checking that the WGM’s
LED Indicator is green.
Step 5: Exit Add a Client mode on the Genie HD DVR to confirm the WGM(s) on
your network.
After you are finished adding all Mini Clients (Wireless and Wired) to your network:
• Return to the Genie HD DVR.
• Select DONE on the Add a Client screen.
• Your Genie network will now operate with the additional WGMs.
:: NOTE
:: NOTE
DIRECTV services not available outside the U.S. DIRECTV programming is available separately and independently of DIRECTV equipment. A valid programming subscription is required to operate DIRECTV equipment. Activate your DIRECTV
programming today at 1.800.DIRECTV (1.800.347.3288). The DIRECTV Genie Mini Client requires DIRECTV Whole-Home Service, Advanced Receiver Service, a Whole-Home Network with an Internet-connected DIRECTV Genie HD DVR
Receiver (HR34, HR44 and above), and the DIRECTV Wireless Video Bridge already installed by a professional DIRECTV Installation Professional. Visit www.directv.com/technology/wholehome and www.directv.com/technology/genie for
more information.
Additional equipment charges apply for each DIRECTV Mini Client. You must activate each new/additional or reactivated Mini Client on your existing account by calling DIRECTV Customer Care at 1-800-531-5000. Connection speeds and
signal strength vary, depending on your Internet Service Provider (ISP). Check with your ISP to confirm your home network speeds. © 2013 DIRECTV. DIRECTV and the Cyclone Design logo, and Genie and the Genie logo are trademarks of
DIRECTV, LLC. 30034-10 .
5
C41W V1.0 MARCH252014
To Previous Page
Loading...
