Genie GCL-MT - Page 10

Sec-2.3
Section 2: Operator Installation
FRONT
SPREADER
BRACKET
WASHER
COTTER PIN
IDLER PIN
IDLER SPROCKET
TRACK BOLTS/
LOCK NUTS
DO NOT INSTALL YET!
SLEEVE
WASHER &
COTTER PIN
THIS SIDE
FIG. 3
FIG. 4
OPERATOR
3. InsertthecarriageintothetracksasshowninFIG.3.
4. Placethespreaderbracketinpositionaroundthedrawbartrack.Donotinsertthetrackboltsandlock
nutsatthistime.Thespreaderbracketwillbeheldinplace(temporarily)bytheidlerpinwhichholds
thesprocket.
5. Installtheidlersprocketinsidethetrackbyinsertingthe7/16”x7”idlerpinthroughonesideofthe
track.Feedpinthroughasleeveandtheidlersprocketfollowedbythesecondsleeve.Place7/16”x
1-1/4”fenderwasherovereachendofidlerpin.Secureidlerpinwithcotterpinthroughtheholeineach
endofidlerpin.FIG.4.