Genie GCL-MT - Page 9

Sec-2.2
Section 2: Operator Installation
1. AttachTracktooperatorusingtwo7/16”-14x1”hexbolts,lockwashers&hexnuts&two1/4”-20x3/4”
grade8boltsandlocknuts.FIG.1.
Verifythatscrewsareproperlyseatedintrack.Failuretoseatscrewscancausecarriagetobindindoor
track.
CAUTION
!
ATTENTION
!
Vériezquelesvissontbienenplacedanslapiste.Silesvissontmallogées,lechariotpeutsecoincer
danslapistedelaporte.
Under12’ 14’
2 3
NOTE: Space chain guides evenly between operator and header.
Add a chain guide for every 4 feet of door height per chart A.
NOTE: Chain guide mounting holes have been pre-drilled at
standard locations along the track. If dierent locations are
needed, hole size should be 17/64” dia. Be sure to de-burr the
holes.
CHAIN GUIDE BRACKET
TRACK BOLTS/LOCK NUTS
PLASTIC CHAIN GUIDE
FIG. 1
FIG. 2
7/16”-14x1”Bolt
7/16”LockWasher
7/16”-14HexNut
1/4”-20x3/4”Grade8Bolt
1/4”-20LockNut
CHART A
2.Installchainguides.