To Next PageTo Next Page
Need help?Do you have a question about the Genie GS-1930 and is the answer not in the manual?
General| Lift Capacity | 500 lbs |
|---|---|
| Gradeability | 25% |
| Power Source | Electric |
| Battery Voltage | 24 V |
| Machine Width | 30 in |
| Machine Length | 1.83 m |
| Drive Speed - Stowed | 4.0 km/h |
| Turning Radius - Inside | 0 m |
| Width | 30 in |
| Drive Speed - Lowered | 4.0 km/h |
| Platform Width | 30 in |
| Battery Type | DC |
| Tire Type | Non-marking |
| Overall Width | 30 in |
| Overall Length | 1.83 m |
Key responsibilities of users for safe machine operation.
Identifies symbols, color coding, and signal words used for hazards.
Outlines hazards associated with misusing the machine.
Warns about dangers of contact with electrical current and required clearances.
Details conditions and actions that can lead to machine tip-over.
Reinforces safety regarding electrical contact and clearance distances.
Discusses factors affecting machine stability and safe platform capacity.
Addresses safety regarding platform guard rails and secure footing.
Explains the functions of buttons and the key switch on the ground panel.
Details the operation of platform controls including joysticks and buttons.
Importance and scope of visual checks before operating the machine.
Procedures for testing all machine functions to ensure proper operation.
Operator responsibilities and safe operating practices for the machine.
Instructions for using the emergency stop buttons to halt all functions.
Steps to extend and retract outriggers for machine stabilization.
Guidelines for safely securing the machine onto transport vehicles.
Proper procedure for lifting the machine using a forklift.
Procedure for inspecting and maintaining the hydraulic oil level.
Steps for inspecting battery condition, connections, and hold-downs.
