English
-10-
●This button is only working in the Record Mode. Press this button to select the desired
flash mode while taking a picture and there are 4 modes available:
Auto → Auto and Red-eye reduction → Off→ Auto
3-8 Mode Display Button
1 This button is only working in the Record Mode. Press this button and you can
change the LCD monitor to several displays.
Standard Æ Full Display Æ Image Only Æ LCD Monitor Off Æ Only Operation
Settings Æ Standard
2 Press the "Mode Display Button" to enter the "Play Mode" to view the images
when the camera is powered off.
3 In the Record Mode, the camera will be auto power off because of the power
saving function. You can press the "Mode Display Button" to turn on the camera
again.
3-9 Macro Button
z Slide down and up the Macro button at the side of camera
to switch between Basic and Macro modes. When
you selected the Macro mode, the green LED located
on the top of the LCD monitor will be on.
Macro
Basic
※If you selected the Macro Mode when using the
camera, the flash off function will be enabled
automatically.
Chapter 4 Navigating Modes and Menus
4-1 Mode Selection
To Next Page
Loading...
