English
-26-
Then click on Record and you can capture the video.
If you want to stop capturing, press ESC or click on Pause
6-6 TV-Out Operation
Using the TV-Out function offered by the camera, you can transfer images to other
display devices, e.g. TV or computer. To transfer the images, follow this method:
1. Please select the correct video type for the connected device before transferring
images. Turn the Mode Dial
to Setup Mode and select the correct
video output type for your selection: NTSC or PAL.
2. When you use this function; please use the video cable provided with the camera
to connect the camera and output device.
3. You can turn on the camera. There will no images shown on the LCD Monitor. All
the images and information will be shown on the output device's display via the
video output cable.
※ The camera will perform normally when you enable the TV-Out function. The only
difference is the location to show the images, and the image information will be from
the LCD Monitor to the video output device's display.
※ While using the camera, after you connect the video cable to the camera, the images
will be no longer shown on the LCD Monitor. If you want to restore the display status on
the LCD Monitor, please disconnect the video cable from the camera.
Chapter 7 Driver Installation
7-1 Installing the Camera Driver to the PC
To Next Page
Loading...
