GENMAC OTTO - Using the Air Compressor; Jump Start Warnings

To Next Page

To Previous Page

OTTO 8 in 1 Emergency Kit

ENGLISH

3. Position the OTTO 8 in 1 Emergency Kit so that you can see the pressure gauge.

4. Make sure the chuck lever is positioned up (away from the chuck opening).

5. Remove the valve cap from the valve stem of the tire.

6. Attach the chuck to the tire’s valve stem.

7. Move the chuck lever down to secure the chuck to the valve stem.

8. Turn compressor switch on to “I” position.

9. Monitor the pressure gauge while inﬂating the tire.

10. When recommended tire pressure has been reached, turn off air compressor.

11. Disconnect hose and replace valve cap.

12. Store the hose in the Air Hose Compartment.

13. Recharge the OTTO 8 in 1 Emergency Kit as soon as convenient.

JUMP START WARNINGS

• This unit is capable of up to 600 Cranking amps which is enough to start a 4–6 cylinder

vehicle. It will not work on some larger 6-cylinder or larger vehicles.

• Lead-acid batteries can release explosive gasses. Failure to follow instructions

may cause property damage, explosion hazard, and/or personal injury.

• Do not smoke while jump starting.

• Jump start a vehicle or boat in a well ventilated area.

• Do not attempt to jump start a frozen battery.

• Do not wear vinyl clothing when jump starting—friction can cause static

electricity sparks.

• Remove all metal jewelry—this can cause short circuits.

• Always use safety glasses when jump starting battery—acid can cause

blindness and/or severe burns.

• Never allow red and black clamps to touch—this can cause power arcing

and/or explosion.

• After use, turn off Power Safety switch.

• Keep out of reach of children.

• Excessive engine cranking can damage the vehicle’s starter motor. If the engine fails to

start after the recommended number of attempts, discontinue jump start procedure and

look for other problems that may need to be corrected.

• If vehicle to be started has a Positive Grounded System (positive battery terminal is con-

nected to chassis):

i. Connect negative (−) black clamp to vehicle battery’s negative terminal.

ii. Connect positive (+) red clamp to vehicle chassis or a solid, non-moving, metal ve-

hicle component or body part. DO NOT clamp directly to positive battery terminal

or moving part.