User’s Manual—Read before using this equipment
15
ENGLISH
JUMPSTARTING
1. Review the Jump Start Warnings.
2. Make sure all vehicle appliances, lights, radio, etc are turned off.
3. Make sure the vehicle’s gear is in “park” position and the brake is set.
4. Make sure all OTTO 8 in 1 Emergency Kit switches are off.
5. Securely connect the red (+) cable clamp to the vehicle’s positive (+) battery terminal.
6. Connect the black (−) cable clamp to a non-moving part on the vehicle.
7. Observe the color of the Reverse Polarity Protection Indicator that is located between the
Battery Status button and Work Light switch.
• If the light is RED, DO NOT TURN ON THE JUMPER SAFETY SWITCH!
i. Cable clamps need to be reversed.
ii. Disconnect the black clamp first then the red clamp.
iii. Reconnect and observe the indicator again.
• If the light is GREEN, turn on the Jumper Safety Switch.
i. Inside the vehicle, turn on the ignition switch and attempt to start the engine.
ii. Crank a maximum of three seconds. If the engine does not start, wait three
minutes before the next attempt.
iii. After the engine starts, turn off the Jumper Safety Switch.
iv. Disconnect the black clamp first, and then disconnect the red clamp.
8. Be sure that the cables and clamps are securely stored.
9. Recharge the OTTO 8 in 1 Emergency Kit as soon as convenient.
NOTE: If the engine does not start, there may be a problem other than a discharged battery.
Call for service.
WORK LIGHT
The Work Light is a cluster of bright LEDs located above the negative Jumper Cable
storage area. The location of the Work Light allows the light to be used while the
OTTO 8 in 1 Emergency Kit is being carried.
• Turn the work light switch (located on front panel) to the “I” position for power on.
• The light will illuminate.
• Turn off while not in use.
To Next Page
Loading...