Using Foam-Type Cleaner on Fabric
Vacuum and brush the area to remove
Always clean a whole trim panel or
any loose dirt.
section. Mask surrounding trim along
stitch or welt lines.
Mix
Multi-Purpose Powdered Cleaner
following
the
directions on
the
container label.
Use suds only and apply
with
clean
Don’t saturate the material.
Don’t rub
it
roughly.
As
soon as you’ve cleaned the
sponge.
section, use a sponge to remove
the
suds.
Rinse the section with a clean, wet
sponge.
Wipe off what’s
left
with a slightly
damp paper towel or cloth.
Then dry
it
immediately with an air
hose, a hair dryer or a heat lamp.
Be careful with a nalr aryer or
heat lamp. You could scorch thl
Wipe with a clean cloth.
Using Solvent-Type Cleaner on
Fabric
First, see if you have to use solvent-type
cleaner at all. Some spots and stains will
clean off better with
just
water and mild
soap.
If you need to use it, then:
Gently scrape excess
soil
from the
trim material with a clean, dull knife
or scraper. Use very little cleaner,
light pressure and clean cloths
263
- -
To Next Page
Loading...
