Features
&
Controls
W@er/Washer
Lever
The lever on the right side
of
the
steering column controls
the
windshield
wipers and washers.
Move the wiper switch
to
the position
you want:
OFF
-
The wipers are off.
INT
-
Intermittent wiper operation
(if your Tracker has this).
In
light
rain or snow, you might want to use
this position rather than continuous
wiping.
LO
-
The wipers will run
continuously at low speed.
HI
-
The wipers will run
continuously at high speed.
19.72
For a single wiping cycle, push the lever
to
MIST.
Hold it there until the wipers Damaged wiper blades may
start, then let go. The wipers will stop prevent you from seeing well
after one cycle.
If
you
want more enough
in
a
storm
to
drive safely.
cycles, hold the lever on
MIST
longer. To avoid damage,
be
sure to clear
Washers
I
I
ice and snow from the wiper
I
Pull the wipedwasher lever toward you
to spray washer fluid on the windshield.
The spray will continue until you release
the lever. This will also turn on the low
meed wiDers.
blades before using them. If
they're frozen to
the
windshield,
carefully loosen or thaw them. If
your blades
do
become damaged,
get new blades
or
blade inserts.
c
I
Heavy snow or ice can overload your
wipers.
A
circuit breaker will stop them
until the motor cools. Clear away snow
or ice to prevent an overload.
To Next Page
Loading...
Need help?
General
