PRV
Press this button to go back
to
the beginning
of the last selection. Press the button again or press
RCL
A
or STOP
to
cancel this
function.
For NXT and PRV to work properly, your tape must
have at least three or four seconds
of
silence between
each selection. If you press RCL
A,
the tape
will
also
change sides.
RPT
Press this button to go to the beginning of the
selection and play it again. Press RPT again to cancel
this
function.
NOISE
REDUCTION:
Press
OU@
to remove noise
from Dolby@
B
NR-encoded tapes.
Dolby@
B
Noise Reduction is manufactured under
license from Dolby Laboratories Licensing Corporation.
Dolby@ and the
DO@
symbol are trademarks of Dolby
Laboratories Licensing Corporation.
RDM:
When playing a tape, press this button during FF
or REW to hear the radio. Press it again to turn the radio
off.
During this operation, only TUNE,
SEEK
and
PSCAN will
work.
TAPE SIDES:
Press RCL
v
A
to switch from one side
of
the tape to the other.
STOP:
Press
this
button to stop the tape and switch to
radio.
EJECT
Press this button to remove the tape and switch
to radio.
Cln:
This message may appear on the display.
If
it does,
your cassette tape player needs to be cleaned. It
will
still
play tapes, but you should clean it
as
soon as possible to
prevent damage to your tapes and player. See “Care of
Your Cassette Tape Player”
in
the Index. After you clean
the player, press and hold EJECT for five seconds to
reset the Cln indicator.
“---”
will
appear
in
the display to
show the indicator was reset.
To Play
a
Compact Disc
Don’t use the mini-discs (three-inch singles). They
won’t eject. Use full-size compact discs.
Insert your disc into the CD slot on your audio system.
If
the disc comes back out,
it
could be
that
the road is
rough, (the disc should
play
when the road is smoother);
the disc is upside down; dirty, scratched or wet; or there
is too much moisture
in
the
air.
(If
there’s too much
moisture
in
the air, wait about one hour and try again.)
If you see Err
on
the display, the disc player
is
too hot to
play the disc. Press
RCL
7
A
to take Err
off
the display.
To Next Page
Loading...
Need help?
General
