Lamps
On
Reminder
Windshield Wipermasher Lever
If
you
turn
the ignition
off,
remove the key, open the
door and leave the lamps on, a chime will remind you to
turn
off
your lamps.
Headlamp High/Low
Beam
First, you must have the
headlamps on. For high
beams, push the turn signal
lever away from you. When
the high beams are
on,
a
blue light on the instrument
panel also will be on.
It
will
go
off
when you switch to
low beam.
To switch back to low beams, pull the lever toward you.
Passing Signal
With the lever in the low beam position, pull the lever
toward you to momentarily switch to high beam (to
~ signal that you are going to pass). When you release the
lever, the headlamps will return to low beam operation.
The lever on the right side
of the steering column
controls the windshield wipers
and
washers.
Move the wiper switch to the position you want:
OFF:
The wipers are
off.
INT:
Intermittent wiper operation. In light rain or snow,
you might want
to
use this position rather than
continuous wiping.
LO:
The wipers will
run
continuously at low speed.
2-30
To Next Page
Loading...
Need help?
General
