HI:
The wipers will run continuously at high speed.
For a single wiping cycle, push the lever to MIST. Hold
it there until the wipers start, then let go. The wipers will
stop after one cycle.
If
you want more cycles, hold the
lever on MIST longer.
Washers
Pull the wipedwasher lever toward you to spray washer
fluid on the windshield. The spray will continue until
you release the lever. This will also turn on the low
speed wipers.
Be sure to clear ice and snow from the wiper blades
before using them. If they’re frozen to the windshield,
carefully loosen or thaw them.
If
your blades do become
damaged, get new blades or blade inserts.
Heavy snow or ice can overload your wipers.
A
circuit
breaker will stop them until the motor cools. Clear away
snow or ice to prevent an overload.
When using concentrated washer fluid,
follow the manufacturer’s instructions for
adding water.
Don’t mix water with ready-to-use washer
fluid. Water can cause the solution to freeze
and damage your washer fluid tank and
other parts
of
the washer system. Also,
water doesn’t clean as well as washer fluid.
Fill your washer fluid tank only
3/4
full
when it’s very cold.
This
allows for
expansion, which could damage the tank
if
it
is completely full.
Don’t
use
radiator antifteeze
in
your
windshield washer.
It
can damage your paint.
2-31
To Next Page
Loading...
Need help?
General
