Zenith16/40 GNSS Series - 2 -
Installation Guide © 2019 GeoMax AG, Widnau Switzerland
Table of Contents
1 INTRODUCTION
2 GENERAL PREPARATION
2.1 Copy Zenith16/40 Firmware on MicroSD card
2.2 Battery Charging
3 PREPARATION OF THE GNSS RECEIVER
3.1 Connecting to the PC
3.2 Receiver connection with Zenith Manager
3.3 Checking the receiver firmware version
3.4 Receiver configuration
3.5 Antenna Management
3.6 Installation of licences
3.7 Disconnecting from the PC
4 EQUIPMENT SETUP
4.1 Rover setup
4.2 Base setup
To Next Page
Loading...
Need help?
General
