Zenith16/40 GNSS Series - 12 -
Installation Guide © 2019 GeoMax AG, Widnau Switzerland
3.5 ANTENNA MANAGEMENT
All available GeoMax GNSS antennas are currently supported in the antenna management
by default. If your Base-Rover set up will include a non GeoMax device, you should make
sure the base antenna is recognised on the Zenith16/40. To do that, it’s needed to add
this specific antenna manually with the Zenith Manager. See how to do it below:
With the receiver connected to Manager, select Antenna from the bottom menu.
To Next Page
Loading...
Need help?
General
