GeoVision GV-Video Server How-To

GeoVision Inc. 2 Revision Date: 2009/8/25
1. Press and then release the Reset button immediately.
2. Press and hold the Load Default button until all 3 LEDs (Power, Ready and Disk
Full/Fault) are on. This may take up to 30 seconds.
3. Release the Load Default button. The process of loading default values is complete, and
the GV-Video Server starts rebooting itself with all 3 LEDs turning off.
4. Wait until the Power and Ready LEDs turn on again. After this all the settings are returned
to default values.
Note: Before the Ready LED is on again, do not unplug the power cable; otherwise the
loading of default values will fail.
Loading Default Settings for GV-Video Server (GV-VS12)
Refer to the figure and instructions below to load default settings for GV-VS12.
1. Unplug and plug the power cable to start.
2. Press and hold the Default button until the Ready LED blinks. This may take up to 30
seconds, and the Ready LED will blink twice.
3. Release the Default button. The process of loading default values is complete, and the
GV-Video Server starts rebooting itself with the 2 LEDs turning off.
4. Wait until the Power and Ready LEDs turn on again. After this all the settings are returned
to default values.
Note: Before the Ready LED is on again, do not unplug the power cable; otherwise the
loading of default values will fail.

GeoVision GV-Video Server Specifications

General

Brand	GeoVision
Model	GV-Video Server
Category	Server
Language	English