GeoVision GV-Recording Server - User Manual

User's Manual V1.2.0.0
GV-Recording Server
RSV12-A-EN

Summary

Chapter 1 Introduction

1.1 System Requirements

Details the hardware and software specifications needed to run the GV-Recording Server software effectively.

Chapter 2 Installation

2.1 Installing the GV-Recording Server

Step-by-step guide for installing the GV-Recording Server software, including prerequisite steps.

2.2 Starting the GV-Recording Server

Instructions on how to launch and access the GV-Recording Server application after installation.

Chapter 3 Getting Started

Add IP Video Devices

Process for discovering and adding IP video devices to the GV-Recording Server.

Assign Storage Paths

Configuring storage paths for recorded video files, including adding new folders and selecting existing ones.

Start Recording Server Service

Enabling the Recording Server and Video Gateway services to start recording and streaming video.

Chapter 4 Active and Passive Mode

4.1 Active Connection

Describes the method where the GV-Recording Server initiates the connection to IP video devices.

4.2 Passive Connection

Explains the method where IP video devices initiate the connection to the GV-Recording Server.

Chapter 5 Administrator Mode

5.2 Camera

5.3 Server

Chapter 6 User Mode

Chapter 7 Connections with Clients

7.1 Connecting with GV-System

7.2 Connecting with Multi View

7.4 Connecting with Remote ViewLog

7.5 Connecting with the GV-Control Center

7.6 Connecting with the GV-Mobile Server

GeoVision GV-Recording Server Specifications

General

Model	GV-Recording Server
Maximum Channels	64
Maximum Number of IP Cameras Supported	64
RAID Support	RAID 0, 1
Network Interface	Gigabit Ethernet
Supported GeoVision Software	GV-VMS
Video Compression	H.265, H.264, MJPEG
Network Protocols	HTTP, HTTPS, RTSP
User Interface	Web interface
Operating System	Windows Server 2019 Standard (64-bit)