________________________________________________
41
English
X Length and Y Length (Box Test)
The Box Test is used to determine the plotter’s printing tolerance (+/-
1mm) by printing a series of 1 x 1 meter boxes. This test should be
performed when the plotter is initially installed and when ink cartridges
are changed.
NOTE: The test must be run with the paper falling to the floor.
1. Click the Start Box Test button (Figure 39) to run the Box
Test.
NOTE: The plotter will begin printing.
2. When the printing is complete, cut the paper and lay it on a flat
surface.
3. Measure and record the measurements in both X and Y
directions. Enter these values in the Actual Length box.
4. Click Confirm.
5. Click Apply.
6. Update the new values from step 3 in the XLength and
YLength boxes.
7. Click Confirm.
8. Click Apply.
9. Repeat the calibration if required.
To Next Page
Loading...