________________________________________________
49
English
Mandrel
Fasteners used to secure paper rolls to the Feed Roll Bar.
Nip Bar Lever
This lever controls the Nip Bar and is located above the Left Side
Column. The DOWN position is the normal operating position and firmly
holds the paper in place. The UP position loosely grips the paper and is
used when loading paper.
Nip Bar and Pinch Rollers
These are six Pinch Rollers attached to the Nip Bar. The Pinch Rollers
hold the paper in place and feed it through the plotter. The Nip Bar
tension is adjusted using the Nip Bar Lever.
ON/OFF Switch
The main power switch that is located behind the Left Side Column.
Paper Take-Up Bar
The paper can be dropped onto the floor or wound up on the Paper
Take-Up Bar. This motor-driven roller can be configured to rotate
clockwise or counter-clockwise.
Power Cord Socket
This socket is located behind the Left Side Column.
Take-On Dancer Bar
Located toward the back of the plotter, this bar senses and measures
paper tension on the Feed Roll Bar and feeds paper accordingly
through the plotter.
To Next Page
Loading...
Need help?
General
