Gesipa FireBird Pro S - 6 Troubleshooting; Blind Rivet Nut Does Not Screw on; Nut Is Not Screwed off; Set Blind Rivet Nut Is Loose

28
GB
6. Troubleshooting
6.1 Blind rivet nut does not screw on
Cause Corrective measures
Nut thread defective Use new nut
Threaded mandrel defective Change threaded mandrel (Point 3.1)
Nut does not rest against nosepiece Threaded mandrel length x incorrect; adapt to nut
length (see point 3.2)
Nut unscrews again Keep switch G pressed until the tool stops (Point
4.1)
No battery Charge battery (Point 5.3)
6.2 Nut is not screwed off
Cause Corrective measures
Nut thread deformed/destroyed due to excessive
setting force
Remove nut using hexagon screwdriver (Point
4.2); see Fig. 5); Reduce setting stroke (Point 3.3)
6.3 Set blind rivet nut is loose
Cause Corrective measures
Setting stroke too small Increase setting stroke in small steps (Section 3.3)
The nut is not completely screwed on the mandrel,
which means that the selected setting stroke is
not reached.
Screw on the nut correctly (Section 4.1)
Selected setting stroke is not reached. Setting force of the device insufcient; observe
working range (Section 2.3)
7. Warranty
The applicable terms and conditions of guarantee shall apply and can be viewed under follo-
wing link: www.gesipa.com/agb