Gespasa GK-7PLUS - SUPERVISOR Mode; SUPERVISOR Menu; CONFIGURATION; SUPERVISOR Mode; SUPERVISOR MENU; CONFIGURATION; CONSOLE

GK-7PLUS CONTROLLER INSTRUCTION MANUAL
14
3.2.5.1. SUPERVISOR Mode / SUPERVISOR Menu / CONFIGURATION
Once into configuration, the display will show the following menu:
> CONSOLE
TANKS
HOSES
GPRS (only in kits with GPRS connection)
ETHERNET (only in kits with ETHERNET connection)
3.2.5.1.1. SUPERVISOR mode / SUPERVISOR MENU / CONFIGURATION / CONSOLE
This part of the configuration allows modifying the parameters that refer to the console operation. These
parameters are:
 USER IDENTIFICATION: It shows the way the users will be identified. The available options are:
- Without identification: where the system will only identify the vehicle not the user.
- By PIN: the PIN (Personal Identification Number) is a code of four digits.
- By identification key + PIN: where each user has assigned an identification key plus a code of four
digits.
 VEHICLE IDENTIFICATION: It shows the way the vehicles will be identified. The available options are:
- Without identification: where the system will only identify the user not the vehicle.
- By identification key: where each vehicle has assigned an identification key.
- By numeric code: where each vehicle has assigned a numeric code among 1 and 99 999.
 PREDETERMINATION: This parameter allows or not enabling the predetermination (preset) in the
supplies. For more information consult the section Predetermination Introduction of the USER MODE.
 SUPERVISOR ID.: It is the identifier code of the SUPERVISOR as long as the system is configured for
the user identification by identification key + PIN. If not, it is irrelevant.
 SUPERVISOR PIN: It is the PIN code associated to the SUPERVISOR.
 LCM HEADING: It is a text of 20 characters, freely editable, that will appear in the first line of the display
while the kit is in the waiting state.
 LANGUAGE: Select the language.
 PRINTER: It specifies if the printer is or is not enabled.
 PRINTER LINE 1: It is a text of up to 32 characters, freely editable, that will appear in the first line of the
ticket.
 PRINTER LINE 2: It is a text of up to 32 characters, freely editable, that will appear in the second line of
the ticket.
 PRINTER LINE 3: It is text of up to 32 characters, freely editable, that will appear in the third line of the
ticket.
 PRINTER LINE 4: It is text of up to 32 characters, freely editable, that will appear in the fourth line of the
ticket.