GK-7PLUS CONTROLLER INSTRUCTION MANUAL
18
3.2.5.3. SUPERVISOR mode / TECHNICAL MENU / INITIALIZATION
Through this option it is possible to initialize the different data files of the system or what it is the same to
eliminate the information that the kit has. Please act with extreme caution in this option as it is not
possible to recover this information once some of the files are initialized,.
Once this option selected, it will appear a menu with the following options:
USER FILE
VEHICLE FILE
SERVICE FILE
CONFIGURATION FILE
ALL
Selecting any of them, the kit will show the following message:
CONFIRM
INITIALIZATION
Confirm with the key <OK> to make effectively the operation or press any other key to exit.
The effect of making an initialization on each one of these files is the following:
USERS: All the authorized users will be eliminated.
VEHICLES: All the authorized vehicles will be eliminated.
SERVICES: All the stored services will be eliminated.
CONFIGURATION: It will be loaded a system configuration by defect. This configuration can be consulted
in the APPENDIX A.
Selecting the option ALL, it will be made an initialization of each and every one of the four files.
3.2.6. GPRS (only in kits with GPRS connection)
Through this option, it is possible to consult the GPRS connection and it is not allowed to be modified. to
configure the parameters linked to the GPRS connection, access the options into 3.2.5.1.4. SUPERVISOR
MODE / SUPERVISOR MENU / CONFIGURATION / GPRS).
STEPGPRS: Number that determines the GPRS connection state
OPERATOR: It informs about the user configured in the GPRS controller parameters.
COVERAGE: GPRS signal in the mobile phone network. Its range is among 0 (without signal) and 31
(maximum signal).
IP: IP address assigned by the mobile phone operator.
To Next Page
Loading...