GK-7PLUS CONTROLLER INSTRUCTION MANUAL
22
CONFIGURE THE NEW SIM CARD:
1. Switch on the GK-7PLUS controller or the kit that has built in it.
2. Access the SUPERVISOR MODE following the instructions of the above section no. 3 and fill in the
options of the OPERATOR (APN), USER and PASSWORD into 3.2.5.1.4. Supervisor Mode /
SUPERVISOR MENU / CONFIGURATION / GPRS, according to the information given by the mobile
phone operator of the SIM card.
3. Restart the GK-7PLUS controller or the kit.
Once the GK-7PLUS controller or the kit is restarted, it is possible to check if there is a correct GPRS
connection into 3.2.5.1.4 Supervisor Mode / SUPERVISOR MENU / CONFIGURATION / GPRS as it is
described in the above section no. 3.
If your GK-7PLUS kit gives the IP address assigned by the mobile phone operator, it means it is connected
to the network.
To Next Page
Loading...