3031 Schüttelinkubator
Shaking Incubator
Seite / Page 16 Rev.02 vom / dated 31.03.2014
5.1 Remote control via PC
An interface module with a terminal on the right-hand side of the incubator produces the data
transmission format RS 232. The interface enables reading of current actual and set values
at any time. In order to set values for the temperature regulator, the shaking frequency
controller or the timer, the incubator has to be switched to remote control mode via a PC
signal. Being in remote control mode, the incubator cannot be operated manually.
5.1.1 Interface protocol
An interface protocol is available for operation of the Shaking Incubator's RS 232 interface.
Please advise model and serial number of the incubator.
5.1.2 Software
The software labworldsoft
®
provides control of temperature and shaking frequency of
Shaking Incubator 3031.
Complete measurement configurations can be memorized with all necessary parameters.
Ready-to-use measuring procedures for various applications are pre-configurated and are
easily retrievable.
Set and actual values of temperature and shaking frequency are available as output signals.
Data input is made online and can be displayed either graphically or numerically.
To Next Page
Loading...