GHL Doser Resource Guide
Release 07/2018
42
4. Locate and select the correct firmware for the Slave Doser. The correct file will be
located in the GHL Control Center folder under “Firmware” and “PAB-Devices”.
5. You will then be asked if you want to update the selected Slave Doser. Click “Yes” and
the update will begin.
6. Once the update is completed, disconnect from your GHL Doser Standalone or Profilux,
restart the updated doser and reconnect all PAB-devices which may have been
disconnected prior to the update.
You can see how-to update a SLAVE dosing pump by clicking the link below.
How to update PAB-devices:
https://youtu.be/dhZKY055qhc
To Next Page
Loading...
Need help?
General